Login or Register to make a submission.

As part of the submission process, authors are required to check off their submission's compliance with all of the following items, and submissions may be returned to authors that do not adhere to these guidelines.

  • The submission has not been previously published, nor is it before another journal for consideration (or an explanation has been provided in Comments to the Editor).
  • The submission file is in OpenOffice, Microsoft Word, RTF, or WordPerfect document file format.
  • The text is 1.5 spaced; uses a 12-point font; employs italics, rather than underlining (except with URL addresses); and all illustrations, figures, and tables are placed within the text at the appropriate points, rather than at the end.
  • The text adheres to the stylistic and bibliographic requirements outlined in the Author Guidelines, which is found in About the Journal.

AUTHOR INSTRUCTION


Journal of Novel Application in Engineering & Technology (JNAET) is an official publication of Creative Pharma Assent (CPA). It is an open access, peer review online international journal, which publish quarterly. JNAET mainly follow Open journal system (OJS) & only publish the original research ideas with a definite innovation and novelty after thorough reviewing. We follow an authentic & impartial review process and believe in fast publication of manuscript


Papers that are merely descriptive or confirmatory in nature, poorly written, lack a hypothesis, fail to offer new insights, or contain conclusions that are not supported by data are unlikely to be accepted for publication in this journal.


Peer review:


All manuscripts are subject to peer review and are expected to meet standards of academic excellence. If approved by the editor, submissions will be considered by peer-reviewers, whose identities will remain anonymous to the authors.A confirmation about the acceptance of the manuscript will be sent to e-mail address of the corresponding author.


Submission of Manuscript:


Authors should submit the articles in MS-word 2003 or 2007 format, no other format is accepted. If equations were used it should be converted by using MS Office equation editor and pasted as image at proper place. All equations should be grouped or may be prepared using equation editor software. All the manuscript can be submitted directly through website after registration into Open journal system (OJS). In case of technical difficulties face by author during submission processes, he may submit the manuscript as attachment to email id at editor.jnaet@gmail.com  The technical team will submit the manuscript online and inform authors about the same. The team will also provide login id and other details to author to enable them to keep a track of manuscript by themselves.


Manuscripts should be concisely written and conform to the following general requirements:




  1. Manuscripts should be type written in double-space in A4 sized sheets, only on one side, with a 2 cm (1”) margin on both sides.

  2. Pages should be numbered consecutively, starting with the title page and for research articles the matter arranged in the following order: Title page, Abstract, Introduction, Materials and Methods, Results, Discussion, Conclusion, Acknowledgements (if necessary), References.

  3. Review articles Should contain up-to-date information, comprehensively cover relevant literature and preferably be written by academicians/scientists/technical experts/ researchers, who have in-depth knowledge on the topic. All format requirements are same as those applicable to full papers. Review articles need not be divided into sections such as materials and Methods and Results and Discussion, but should definitely have an Abstract, Introduction and well organized reference section.

  4. All tables and figures should be aligned in their proper place (separate tables and figures is not acceptable, unless asked by the editor). Follow standard format for the list of symbols and Abbreviations.



Title Page - Title page should contain title of the paper in bold face, (font size 12), names of the authors in normal face, (font size 12) followed by the address(es). The author to whom all correspondence be addressed should be denoted by an asterisk mark. Names of the authors should appear as initials followed by surnames. Full names may be given in some instances to avoid confusion. Names should not be prefixed or suffixed by titles or degrees. Names should be followed by the complete postal address(es) where the research work has been carried out. At the bottom left corner of the title page, please mention “*Address For correspondence” and provide a functional e-mail address.


Abstract - Should start on a new page after the title page. Abstracts should briefly reflect all aspects of the study, as most databases list mainly abstracts.


Key-words - Provide four to six appropriate key words that are related to the content of manuscript. Key words should be mention just below the abstract section.


Introduction - Shall start on next page after the abstract. The Introduction should lead the readers to the importance of the study; tie-up published literature with the aims of the study and clearly states the rationale behind the investigation.


Materials and Methods - Shall start as a continuation to introduction on the same page. All important materials used along with their source shall be mentioned. The main methods used shall be briefly described, citing references. New methods or substantially modified methods may be described with sufficient detail. The statistical method and the level of significance chosen shall be clearly stated. JNAET encourage works that has been subjected to an appropriate statistical test at one level of significance.


Results - All findings presented in tabular or graphical form shall be described in this section. All Tables and figures must have a title or caption and a legend to make them self-explanatory. Results section shall start after materials and methods section on the same page.


Discussion - This section should follow results, deal with the interpretation of results, convey how they help increase current understanding of the problem and should be logical. Unsupported hypothesis should be avoided. The Discussion should also state the future prospects of the study that need to be further explored. Results and discussion of results may also be combined under one section as Results and Discussion.


Table:- All tables should be numbered orderly and self explanatory.  Large size tables may be split into two or more tables so that it can be accommodated within the page size. Table width and cell sizing should be even and all the content should be centered. Number and title of the tables should be given over the tables without any border and shading. 


Ex: Table 1: Table showing the number of villages covered under this study
Figures:- All the submitted images should have enough resolution, at least 300 dpi,  inferior images will be removed. All figures should be numbered orderly; should pasted sheet after the reference. Figure title should be self explanatory & should be mentioned below the figure.


Ex:Figure 1: Image showing the map of the study area.


Acknowledgements - Should be given after the text (if any)


Conflicts of Interest: Authors must identify and declare any personal circumstances or interest that may be perceived as inappropriately influencing the representation or interpretation of reported research results. If there is no conflict of interest, please state "The authors declare no conflict of interest." Any role of the funding sponsors in the design of the study; in the collection, analyses or interpretation of data; in the writing of the manuscript, or in the decision to publish the results must be declared in this section. If there is no role, please state "The founding sponsors had no role in the design of the study; in the collection, analyses, or interpretation of data; in the writing of the manuscript, and in the decision to publish the results".


References


Should be numbered consecutively in the order in which they are first mentioned in the text (not in alphabetic order). JNAET follows IEEE referencing style. Identify references in text, tables, and legends by Arabic numerals in superscript in square brackets. Avoid using abstracts as references.


Use the style of the examples below:


PRINT REFERENCES


Book


Author(s). Book title. Location: Publishing company, year, pp.


Example: W.K. Chen. Linear Networks and Systems. Belmont, CA: Wadsworth, 1993, pp. 123-35.


Book Chapters


Author(s). “Chapter title” in Book title, edition, volume. Editors name, Ed. Publishing location: Publishing company, year, pp.


Example: J.E. Bourne. “Synthetic structure of industrial plastics,” in Plastics, 2nd ed., vol. 3. J. Peters, Ed. New York: McGraw-Hill, 1964, pp.15-67.


Article in a Journal


Author(s). Article title. Journal title, vol., pp, date.


Example: G. Pevere. œInfrared Nation. The International Journal of Infrared Design, vol. 33, pp. 56-99, Jan. 1979.


Articles from Conference Proceedings (published)


Author(s). “Article title.” Conference proceedings, year, pp.


Example: D.B. Payne and H.G. Gunhold. “Digital sundials and broadband technology,” in Proc. IOOC-ECOC, 1986, pp. 557-998.


Papers Presented at Conferences (unpublished)


Author(s). “Paper’s title,” Conference name, Location, year.


Example: B. Brandli and M. Dick. “Engineering names and concepts,” presented at the 2nd Int. Conf. Engineering Education, Frankfurt, Germany, 1999.


Standards/ Patents


Author(s)/Inventor(s). “Name/Title.” Country where patent is registered. Patent number, date.


Example: E.E. Rebecca. “Alternating current fed power supply.” U.S. Patent 7 897 777, Nov. 3, 1987.


ELECTRONIC REFERENCES


Books


Author. (year, Month day). Book title. (edition). [Type of medium]. Vol. (issue). Available: site/path/file [date accessed].


Example: S. Calmer. (1999, June 1). Engineering and Art. (2nd edition). [On-line]. 27(3). Available: www.enggart.com/examples/students.html [May 21, 2003].


Journal


Author. (year, month). “Article title.” Journal title. [Type of medium]. Vol. (issue), pages. Available: site/path/file [date accessed].


Example: A. Paul. (1987, Oct.). “Electrical properties of flying machines.” Flying Machines. [Online]. 38(1), pp. 778-998. Available: www.flyingmachjourn/properties/fly.edu [Dec. 1, 2003].


World Wide Web


Author(s)*. “Title.” Internet: complete URL, date updated* [date accessed]. M. Duncan. “Engineering Concepts on Ice. Internet: www.iceengg.edu/staff.html, Oct. 25, 2000 [Nov. 29, 2003].


Odd Sources


Newspaper


Author(s)*. “Article title.” Newspaper (month, year), section, pages.


Examples: B. Bart. “Going Faster.” Globe and Mail (Oct. 14, 2002), sec. A p.1. “Telehealth in Alberta.” Toronto Star (Nov. 12, 2003), sec. G pp. 1-3.


Dissertations and Theses


Author. “Title.” Degree level, school, location, year.


Example: S. Mack. “Desperate Optimism.” M.A. thesis, University of Calgary, Canada, 2000.


Lecture


Lecturer(s). Occasion, Topic: “Lecture title.” Location, date.


Example: S. Maw. Engg 251. Class Lecture, Topic: “Speed skating.” ICT 224, Faculty of Engineering, University of Calgary, Calgary, Alberta, Oct. 31, 2003.


E-mail


Author. Subject line of posting. Personal E-mail (date).


Example: J. Aston. “RE: new location, okay?” Personal e-mail (Jul. 3, 2003).


Internet - Newsgroup


Author or Topic*, “Title,” Complete network address, date when it was updated [date accessed].


Example: G.G. Gavin. “Climbing and limb torsion #3387,” USENET: sci.climb.torsion, Apr. 19, 2000 [Oct. 4, 2002].